Discount Flooring Depot
0
Call us on 0161 6419 996 or click here to request a callback
  • 0
FREE First class samples
Got a cheaper price? We'll Match It !
Express delivery available

HOW TO LAY ENDURA LVT FLOORING

Our Endura Luxury Vinyl flooring click system allows the floor to be installed using the tongue-in-groove or groove-under-tongue method. The simplest way, however, is to use the groove-under-tongue method, working from left to right along your wall. 

 

It’s important to note that there are many different laminate installation systems and you should always refer to your manufacturer’s guide before installing.

Tools Needed for Fitting Luxury Vinyl Click Flooring

Recommended Tools:

  • Tape measure
  • Pencil
  • Rubber hammer
  • Straight edge or string line 
  • Utility knife
  • Set square
  • Spacers

To make things easier for you, we’ve included the basic tools you’ll need in our installation kits.

Preparation

PREP

  • Our Endura vinyl flooring can be installed over concrete, screed, timber and plywood subfloors and all evenly spread underfloor heating systems
  • Sweep, vacuum and clean the sub-floor of the room you’re planning to lay, ensuring it is fully dry and clear of all debris 
  • Lay down the specific LVT underlay foil side down and ensure a gap of 16mm gap around any pipes

How to Lay Laminate Flooring

PLEASE NOTE: Always check the manufacturer’s recommended installation guide before installing. 

  1. Begin by laying the first row in the corner of the room on your left-hand side as you face the wall. Working from left to right and with the tongue towards yourself.
  2. Lay the first row and use the rubber hammer to tap down on the short sides to connect the panels.
  3. Use spacers to fill out any contours in the wall and ensure it is straight. 
  4. For the end piece of the row, measure the final plank to fit, ensuring that the recommended expansion gap is kept, and cut to size. 
  5. When laying the second row ensure that the joint is at least 20 to 30 cm different from the row while installing at random intervals.
  6. Fit the second panel by sliding the groove under at angle of 25 degrees, into the tongue of the previous row. To ensure a tight fit knock along the long joint with the rubber hammer. 
  7. Continue this pattern until only the final row remains. 
  8. To fit the last row, lay a panel on top of the previous row with the groove towards the wall. Lay another panel upside down up to the edge of the wall and mark the panel underneath. Cut the panel to size and fit the last row. 

To ensure a professional finish and bridge any gaps between your laminate and doorway, apply door trims on the line where your flooring meets the door and corresponding room.

Top